Coil-Sert® Inserts are supplied in coarse and fine threads. Type 2, Type 4 and Type 6 Tooling are used for finer pitch inserts, which are larger in the free state than the coarse pitch inserts. They have to be “pre-wound” to a smaller diameter for installation. Type 1, Type 3 and Type 5 Tooling (threaded mandrel) is used for coarse pitch inserts.
HAND INSERTING TOOL (PREWINDER) - This type of tool is ideal for installing inserts in small production runs or in areas where compressed air or electricity are not available and offers a quicker alternative to the simple hand Installation tool.
THREADED MANDREL - This mandrel is wound into the insert which is then wound into the tapped hole. If it is a fine thread, a prewinder will be included. Type 5 & Type 6 are used in the kits for minimal repair.
Type 1 Installation Tool Threaded Mandrel (sizes 2-56 and 3-48) Part Numbers |
Type 2 Hand Inserting Tool (Prewinder Tool) Part Numbers |
Type 3 Installation Tool (Threaded Mandrel) Part Numbers |
Type 4 Non-Captive Prewinder Part Numbers |
Type 5 Installation Tool (Threaded Mandrel) Part Numbers |
Type 6 Installation Tool (Threaded Mandrel with Prewinder) Part Numbers |
Copyright © 2013 Inserts and Kits Inc. | Santa Ana, California 92705 | ISO 9001:2008 Certified | 800-213-5304 | sales@coilsert.com